Borg & Overstrom U1 Install & Operation Manual page 17

CO2 Bottle Installation - Sparkling Versions Only
1
Unpack CO2 Regulator and fit elbow fitting
to spigot outlet.
4
Stand the cylinder in a suitable place.
7
Allow the machine to stand for 8 - 12
minutes for the initial chilling process to
complete.
Borg & Overström
2
Attach the regulator to the disposable CO2
bottle, ensuring the small pressure relief
vent in the stem is facing away from you or
anyone else. Ensure the regulator is closed.
Hand tighten securely.
5
We recommend between 3.5 - 4 bar(58
PSI) (max). Do not exceed 4 bar pressure.
10
mins
Install & Operation Manual
3
Connect the assembled CO2 bottle and
regulator to the CO2 inlet using a ¼" pipe.
6
58 PSI
It is necessary to prime the sparkling system
with CO2 - push the sparkling button for a
few seconds until CO2 is coming through.
Check and adjust the CO2 pressure
accordingly.
17 GB