Download Print this page

Advertisement

Quick Links

User Guide
U2
Dispense Options
Chilled
Ambient
Contents
Component/Feature Overview
Operation
Functions & Controls
General Safety
CO2 Bottle Installation
Sparking
NOTE: This booklet to be left with
appliance following installation
GB

Advertisement

loading

Summary of Contents for Borg & Overstrom U2

  • Page 1 User Guide Dispense Options Chilled Ambient Sparking Contents Component/Feature Overview Operation Functions & Controls General Safety CO2 Bottle Installation NOTE: This booklet to be left with appliance following installation...
  • Page 2 1 no Tap Tower Dispense 2/3 no Tap Spacers Lever 2/3 no Tap Lever sets 1 no u2 Dispense Label Set 1 no u2 Tap Nut 1 no u2 Mounting Gasket Cold Water Tap Ambient Water Tap Sparkling Water Tap...
  • Page 3 S2 Undercounter - Major Components Contents: 1 no Undercounter Unit 1 no 2.0m Power Cord Set 1 no Co2 Regulator with Gauge & Connection tube 1 no Stainless Steel Drip Tray (c/w with Drain Outlet Cap) 1 no Ventilation Ducting Kit 1 no Ventilation Grille 3 no Outlet Supply Pipes Faucet Connection Harness...
  • Page 4: Operation

    Operation Eliwell Control Panel Digital Display Control Button Function Button Setting Button Control Button Basic Settings Adjusting the Set Point: 1. Switch on Mains power – the display will flash several times, then the fridge system will switch on and the display will give a steady reading, this is the temperature of the water bath sensor.
  • Page 5: Functions And Controls

    Functions & Controls Tap Control Panel Ambient Water Cold Water Tap SparklingWater Tap* Use the valves on the sides of the taps to CLOSED increase or decrease flow rate. Lever in the upright position is fully closed. OPEN OPEN Flow Restrictor Lever *Sparkling versions only.
  • Page 6: General Safety

    General Safety General Safety - Always place the dispenser in its vertical position, on a surface which can capably support its weight. - During use this machine must remain in its upright position. - Adequate ventilation must be allowed for - we recommend using the supplied ventilation ducting kit.
  • Page 7 CO2 Bottle Installation - Sparkling Versions Only Unpack CO2 Regulator and fit Attach the regulator to the Connect the assembled CO2 elbow fitting to spigot outlet. disposable CO2 bottle, ensuring bottle and regulator to the CO2 the pressure relief vent is facing inlet using a ¼”...
  • Page 8 +44 1362 695 006 Telephone © Copyright Borg & Overström. +44 (0)1362 695 006 This guide is printed by Borg & Overström and Email shall not be reproduced or copied in anyway. sales@borgandoverstrom.com Ref: 838023 borgandoverstrom.com Document Reference: U2.S2.UG.v09082018...

This manual is also suitable for:

S2