Borg & Overstrom U2 40L User Manual

Borg & Overstrom U2 40L User Manual

Hide thumbs Also See for U2 40L:

Advertisement

U2 40L - User Guide
Dispense Options
Chilled
Ambient
Contents
Component/Feature Overview
Operation
Functions & Controls
General Safety
CO2 Bottle Installation
Telephone
+44 (0)1362 695 006
Email
sales@borgandoverstrom.com
borgandoverstrom.com
Sparking
NOTE: This booklet to be left with
appliance following installation
GB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the U2 40L and is the answer not in the manual?

Questions and answers

Summary of Contents for Borg & Overstrom U2 40L

  • Page 1 U2 40L - User Guide Dispense Options Chilled Ambient Sparking Contents Component/Feature Overview Operation Functions & Controls General Safety CO2 Bottle Installation Telephone +44 (0)1362 695 006 Email sales@borgandoverstrom.com NOTE: This booklet to be left with borgandoverstrom.com appliance following installation...
  • Page 2 Component/ Feature Overview U2 Tap - Major Components Contents: 1 no Tap Tower Dispense 2/3 no Tap Spacers Lever 2/3 no Tap Lever sets 1 no u2 Dispense Label Set 1 no u2 Tap Nut 1 no u2 Mounting Gasket Cold Water Tap Ambient Water Tap Sparkling Water Tap...
  • Page 3 Undercounter - Major Components Contents: 1 no Undercounter Unit 1 no 2.0m Power Cord Set 1 no Co2 Regulator with Gauge & Connection tube (Sparkling option only) 1 no Stainless Steel Drip Tray (c/w with Drain Outlet Cap) 1 no Ventilation Ducting Kit 1 no Ventilation Grille 3 no Outlet Supply Pipes Faucet Connection Harness...
  • Page 4: Operation

    Operation Eliwell Control Panel Digital Display Control Button Function Button Setting Button Control Button Basic Settings Adjusting the Set Point: 1. Switch on Mains power – the display will flash several times, then the fridge system will switch on and the display will give a steady reading, this is the temperature of the water bath sensor.
  • Page 5: Functions And Controls

    Functions & Controls Tap Control Panel Ambient Water Cold Water Tap SparklingWater Tap Use the valves on the sides of the taps to CLOSED increase or decrease flow rate. Lever in the upright position is fully closed. OPEN OPEN Flow Restrictor Lever...
  • Page 6: General Safety

    General Safety General Safety - Always place the dispenser in its vertical position, on a surface which can capably support its weight. - During use this machine must remain in its upright position. - Adequate ventilation must be allowed for - we recommend using the supplied ventilation ducting kit.
  • Page 7: Co2 Bottle Installation

    CO2 Bottle Installation Unpack CO2 Regulator and fit Attach the regulator to the Connect the assembled CO2 elbow fitting to spigot outlet. disposable CO2 bottle, ensuring bottle and regulator to the CO2 the pressure relief vent is facing inlet using a ¼” pipe. away from you.
  • Page 8 For full distributor service manual visit: www.borgandoverstrom.com/dealer/service-manuals Customer services: aftersales@borgandoverstrom.com call +44 1362 695 006 © Copyright Borg & Overström. This guide is printed by Borg & Overström and shall not be reproduced or copied in anyway. Document Reference: U2.40.UG.v27042018...

Table of Contents