Installing Hdd; Connecting With Exterior Device - Eneo MSR-24N040005A User Manual

Multisignal hd video recorder, hd-tvi, ahd, 960h, 2xsata, hdmi
Table of Contents

Advertisement

2.1

Installing HDD

How to install HDD in the device:
Attention
1 Always switch off and unplug the unit.
2 Unscrew with a screw driver (+) and open the unit cover.
3 Install HDD in the bottom case.
4 Connect a data cable and power cable with HDD.
5 Close the cover and tighten screws.
2.2

Connecting with Exterior Device

How to connect each port to rear section of the unit:
1 Place the unit in a stable flat surface.
2 Make a room between front/rear sides of the device not to break connectors.
Warning
3 Check to switch off and unplug the unit.
Warning
4 Connect input ports of camera.
Note
5 Connect an audio input port with a Mic and output port with a speaker.
Note
Withdraw the mains plug before installing HDD to reduce the risk of injury or
electrical shock, or device malfunction.
Make sure to check the compatibility of HDD with the device.
Do NOT install the device too close to the wall. Protrusive connects rear the unit
may be forcedly curved or pressed, which cause fires, electric shocks, or injury.
Make sure to withdraw the mains plug before installing the device.
Connecting a camera port with the unit automatically detects the camera.
Assure regulations in the area whether recording to be legal or not.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr-24n080005aMsr-24n160005a223984

Table of Contents