Installing Hdd; Connecting With Exterior Device - Eneo MSR-24N040004A User Manual

2.1

Installing HDD

How to install HDD in the device:

Withdraw the mains plug before installing HDD to reduce the risk of injury or
electrical shock, or device malfunction.
Attention

Make sure to check the compatibility of HDD with the device.
1 Always switch off and unplug the unit.
2 Unscrew with a screw driver (+) and open the unit cover.
3 Install HDD in the bottom case.
4 Connect a data cable and power cable with HDD.
5 Close the cover and tighten screws.
2.2

Connecting with Exterior Device

How to connect each port to rear section of the unit:
1 Place the unit in a stable flat surface.
2 Make a room between front/rear sides of the device not to break connectors.
Do NOT install the device too close to the wall. Protrusive connects rear the unit
may be forcedly curved or pressed, which cause fires, electric shocks, or injury.
Warning
3 Check to switch off and unplug the unit.
Make sure to withdraw the mains plug before installing the device.
Warning
4 Connect input ports of camera.
Note
Connecting a camera port with the unit automatically detects the camera.
5 Connect an audio input port with a Mic and output port with a speaker.
Note
Assure regulations in the area whether recording to be legal or not.
7