Install The Removable Terminal Block - Allen-Bradley C Series Installation Instructions Manual

2. Verify that the DIN rail locking screw is in the horizontal position.
You cannot insert the module if the locking mechanism is unlocked.
1734-TB Base
Turn the keyswitch to
align the number with the
notch. Notch position 3 is
shown.
Be sure that the DIN rail
locking screw is in the
horizontal position.
3. Insert the module straight down into the mounting base and press to secure.
The module locks into place.

Install the Removable Terminal Block

A Removable Terminal Block (RTB) is supplied with your wiring base assembly. To remove, pull up on the RTB handle. This allows the mounting base to be removed and
replaced as necessary without removing any of the wiring. To reinsert the Removable Terminal Block, proceed as follows.
WARNING: When you connect or disconnect the Removable Terminal Block (RTB) with field side power applied, an electric arc can occur. This could
cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
1. Insert the end opposite the handle into the base unit.
This end has a curved section that engages with the wiring base.
2. Rotate the terminal block into the wiring base until it locks itself in place.
1734-TOP Base
45696
Rockwell Automation Publication 1734-IN033E-EN-E - February 2021
POINT I/O 8 Channel High Density Current Input Module Installation Instructions
Be sure that the DIN rail
locking screw is in the
horizontal position.
Turn the keyswitch to
align the number with the
notch. Notch position 1 is
shown.
45697
7