Install The Removable Terminal Block - Allen-Bradley POINT I/O 1734-IB4D Installation Instructions Manual

POINT I/O 24V DC 4-channel Discrete Input Module with Diagnostics

Install the Removable Terminal Block

Read this for information if a removable terminal block (RTB) is supplied with your
wiring base assembly, noting that 1734-TOP and 1734-TOPS bases do not have an RTB.
To insert the RTB, proceed as follows. Note that if you pull up on the RTB handle to
remove the RTB, you can remove and replace the mounting base as necessary without
removing any of the wirings.
1. Insert the end opposite the handle into the base unit, noting that this end has a
curved section that engages with the wiring base.
2. Rotate the terminal block into the wiring base until it locks itself into place.
3. If an I/O module is installed, snap the RTB handle into place on the module.
Publication 1734-IN029B-EN-E - July 2018
13