Configuring Nat/Route Mode; Using The Web-Based Manager To Configure Nat/Route Mode - Fortinet FortiGate FortiGate-5005FA2 Security System Manual

Quick Configuration Guide

Configuring NAT/Route mode

Using the web-based manager to configure NAT/Route mode

1
2
3
FortiGate-5005FA2 Security System Guide
01-30000-0377-20070201
Use Table 5 to gather the information you need to customize NAT/Route mode
settings for the FortiGate-5005FA2 security system. You can use one table for
each module to configure.
Table 5: FortiGate-5005FA2 module NAT/Route mode settings
Admin Administrator Password:
IP:
port1
Netmask:
IP:
port2
Netmask:
IP:
port3
Netmask:
IP:
port4
Netmask:
IP:
port5
Netmask:
IP:
port6
Netmask:
IP:
port7
Netmask:
IP:
port8
Netmask:
Device (Name of the Interface
connected to the external
network):
Default Gateway IP address:
Default Route
The default route consists of the name of the interface connected
to an external network (usually the Internet) and the default
gateway IP address. The default route directs all non-local traffic to
this interface and to the external network.
Primary DNS Server:
DNS Servers
Secondary DNS Server:
Connect port1 of the FortiGate-5005FA2 module to the same hub or switch as the
computer you will use to configure the FortiGate module.
Note: If you cannot connect to port1, see
page 22.
Configure the management computer to be on the same subnet as the port1
interface of the FortiGate-5005FA2 module. To do this, change the IP address of
the management computer to 192.168.1.2 and the netmask to 255.255.255.0.
To access the FortiGate web-based manager, start Internet Explorer and browse
to https://192.168.1.99 (remember to include the "s" in https://).
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
"Using the CLI to configure NAT/Route mode" on
Configuring NAT/Route mode
21