Using The Cli To Configure Nat/Route Mode - Fortinet FortiGate FortiGate-5005FA2 Security System Manual

Configuring NAT/Route mode

Using the CLI to configure NAT/Route mode

22
4 Type admin in the Name field and select Login.
To change the admin administrator password
1 Go to System > Admin > Administrators.
2 Select Change Password for the admin administrator and enter a new password.
To configure interfaces
1 Go to System > Network > Interface.
2 Select the edit icon for each interface to configure.
3 Set the addressing mode for the interface. (See the online help for information.)
• For manual addressing, enter the IP address and netmask for the interface that
you added to Table 5 on page
• For DHCP addressing, select DHCP and any required settings.
• For PPPoE addressing, select PPPoE and enter the username and password
and any other required settings.
To configure the Primary and Secondary DNS server IP addresses
1 Go to System > Network > Options.
2 Enter the Primary and Secondary DNS IP addresses that you added to
page 21 as required and select Apply.
To configure the Default Gateway
1 Go to Router > Static and select Edit icon for the static route.
2 Select the Device that you recorded above.
3 Set Gateway to the Default Gateway IP address that you added to
page 21.
4 Select OK.
1 Use the serial cable supplied with your FortiGate-5005FA2 module to connect the
FortiGate Console port to the management computer serial port.
2 Start a terminal emulation program (HyperTerminal) on the management
computer. Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control
None.
3 At the Login: prompt, type admin and press Enter twice (no password required).
4 Change the administrator password.
config system admin
edit admin
set password <password>
end
21.
FortiGate-5005FA2 Security System Guide
Quick Configuration Guide
Table 5 on
Table 5 on
01-30000-0377-20070201