Configuring Transparent Mode; Using The Web-Based Manager To Configure Transparent Mode - Fortinet FortiGate FortiGate-5005FA2 Security System Manual

Quick Configuration Guide
5
6
7
8

Configuring Transparent mode

Using the web-based manager to configure Transparent mode

1
FortiGate-5005FA2 Security System Guide
01-30000-0377-20070201
Configure the port1 internal interface to the setting that you added to
page 21.
config system interface
edit port1
set ip <intf_ip>/<netmask_ip>
end
Repeat to configure each interface as required, for example, to configure the port2
interface to the setting that you added to
config system interface
edit port2
...
Configure the primary and secondary DNS server IP addresses to the settings
that you added to Table 5 on page
config system dns
set primary <dns-server_ip>
set secondary <dns-server_ip>
end
Configure the default gateway to the setting that you added to
config router static
edit 1
set device <interface_name>
set gateway <gateway_ip>
end
Use Table 6 to gather the information you need to customize Transparent mode
settings.
Table 6: Transparent mode settings
Admin Administrator Password:
IP:
Netmask:
Management IP
The management IP address and netmask must be valid for the
network where you will manage the FortiGate-5005FA2 unit.
Default Gateway IP address:
In Transparent mode the default route requires the default gateway IP
Default Route
address. The default route directs all non-local traffic to the external
network.
Primary DNS Server:
DNS Servers
Secondary DNS Server:
Connect port1 of the FortiGate-5005FA2 module to the same hub or switch as the
computer you will use to configure the FortiGate module.
Note: If you cannot connect to port1, see
page 24.
Table 5 on page 21.
21.
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
"Using the CLI to configure Transparent mode" on
Configuring Transparent mode
Table 5 on
Table 5 on page 21.
23