Command Line Interface (Cli); Factory Default Settings - Fortinet FortiGate FortiGate-5005FA2 Security System Manual

Factory default settings

Command Line Interface (CLI)

Factory default settings
20
The CLI is a full-featured management tool. Use it to configure the administrator
password, the interface addresses, the default gateway, and the DNS server
addresses.
Requirements:
• The serial connector that came packaged with your FortiGate-5005FA2
module.
• Terminal emulation application (for example, HyperTerminal for Windows) on
the management computer.
The FortiGate-5005FA2 unit ships with a factory default configuration. The default
configuration allows you to connect to and use the FortiGate-5005FA2 web-based
manager to configure the FortiGate-5005FA2 module onto the network. To
configure the FortiGate-5005FA2 module onto the network you add an
administrator password, change the network interface IP addresses, add DNS
server IP addresses, and, if required, configure basic routing.
Table 4: FortiGate-5005FA2 factory default settings
Operation Mode
Administrator Account
port1 IP/Netmask
port2 IP/Netmask
port3 to port8 IP/Netmask
Default route
Primary DNS Server:
Secondary DNS Server:
Note: At any time during the configuration process, if you run into problems, you can reset
the FortiGate-5005FA2 module to the factory defaults and start over. From the web-based
manager go to System > Status find System Operation at the bottom of the page and
select Reset to Factory Default. From the CLI enter execute factory reset.
NAT/Route
User Name: admin
Password: (none)
192.168.1.99/24
192.168.100.99/24
0.0.0.0/0.0.0.0
Gateway: 192.168.100.1
Device: port2
65.39.139.53
65.39.139.53
FortiGate-5005FA2 Security System Guide
Quick Configuration Guide
01-30000-0377-20070201