Installing Fortigate-5005Fa2 Modules - Fortinet FortiGate FortiGate-5005FA2 Security System Manual

Installing FortiGate-5005FA2 modules

Installing FortiGate-5005FA2 modules
10
Caution: Handling the SFP transceivers by holding the release latch can damage the
!
connector. Do not force the SFP transceivers into the cage slots. If the transceiver does not
easily slide in and click into place, it may not be aligned correctly. If this happens, remove
the SFP transceiver, realign it and slide it in again.
3 For cage slots 1 to 6, hold the sides of the SFP transceiver and slide SFP
transceiver into the cage socket until it clicks into place.
4 For cage slots 7 and 8, turn each SFP transceiver over before sliding it into the
cage slot until it locks into place.
The FortiGate-5005FA2 module must be fully installed in a chassis slot, with
extraction levers closed and locked, and mounting knots fully tightened for the
FortiGate-5005FA2 module to receive power and operate normally. If the
FortiGate-5005FA2 module is not receiving power, the IPM LED glows solid blue
and all other LEDs remain off.
It is important to carefully seat the FortiGate-5005FA2 module all the way into the
chassis, to not use too much force on the extraction levers, and to make sure that
the extraction levers are properly locked. Only then will the FortiGate-5005FA2
module power-on and start up correctly.
Figure 2: FortiGate-5005FA2 module mounting components
Alignment Pin
Mounting
Extraction
Knot
Lever
Alignment Pin
Mounting
Knot
Extraction
Lever
You can install SFP transceivers into the FortiGate-5005FA2 front cage slots
either before or after installing the module into a chassis. See
transceivers" on page
Closed
Alignment Pin
Lock
Open
Alignment Pin
Lock
9.
FortiGate-5005FA2 Security System Guide
Hardware installation
Mounting
Extraction
Knot
Lever
Lock
Extraction
Lever
Mounting
Knot
Lock
"Installing SFP
01-30000-0377-20070201