Table of Contents
Advertisement
5 – FUNTIONING AND USE
This is a blinking messages that must be acknowledged pressing the key STOP
This messages suggest to replace both 5 and 20 microns filters.
DISPLAY INDICATIONS DURING PRODUCTION
During the normal functioning of the watermaker the display gives the following indications:
Pump 1 OFF/ON
Pump 2 OFF/ON
S = wait This means that the salinity meter is still completing calculations.
S = OK Quality of the produced water good
S = MED Quality of the produced water medium (micro Siemens 1500-2000)
S = BAD Quality of the produced water bad (micro Siemens over 2000).
In this last case, please stop the watermaker and schedule a service.
TIME It is the time from the starting. If the timer function has been used the time will indicate the remaining
time to stop.
THE PRESENT MANUAL BELONGS TO -
(
micro Siemens 0-1500)
Schenker Italia
- ALL RIGHTS RESERVED
34
COD.
80S12/24.D.2018
EN
Advertisement
Table of Contents
