Table of Contents
Advertisement
EN
5 – FUNTIONING AND USE
COD.
80S12/24.D.2018
5. FUNCTIONING AND USE
5.1 Command description
Remote control panel
Fig. 5.1
KEYBOARD FEATURES
The panel keyboard has a total of four push button. The display light switches off after 15 minutes of not use.
Pushing any button, the display will light again, without activate any other command. The functions of the
push buttons are:
START Used to start the system.
If it is pushed shortly the system starts and the unit will run indefinitely until will be pushed STOP.
If it is pushed for at least 3 seconds the system starts, and will stop automatically after the working hours
selected with the timer (see menu functions).
It can anyway be stopped before, pushing STOP.
It is used as well to scroll the different options in the single menu.
STOP Used to stop the system.
The system, once pushed STOP, usually doesn't stop suddenly. It awaits for the correct positioning of the
internal valve (2-3 seconds), and then stops automatically.
If the automatic washing is activated (washing light on), the system, once pushed STOP, will perform the
automatic washing (1 min) before stops.
The push button STOP is used as well to exit from the menu function.
WASHING Used to rinse the system automatically with fresh water.
If it is pushed shortly the system will get ready to perform an automatic washing (1 minute long) once the
system will be stopped.
If it is pushed for at least 3 seconds the system will just perform a 10 minutes rinsing, without suck up sea
water.
MENU Used to enter into the MENU mode and modify some parameters.
Pushing it repeatedly the different MENU options can be scrolled.
On his turn the START push button allows to scroll the different options of the single menu.
The system recognizes the current value without any further command.
The STOP push button allows to exit from the MENU function.
MENU OPTIONS
Schenker Italia
THE PRESENT MANUAL BELONGS TO -
- ALL RIGHTS RESERVED
30
Advertisement
Table of Contents
