Table of Contents
Advertisement
5 – FUNTIONING AND USE
Push STOP to acknowledge the message.
This messages means that an LOW block of the machine occurred, and then the pumps has been switched
off as safety procedure. In this case is suggested to check the sea water inlet connections.
•
HIGH PRESSURE
Push STOP to acknowledge the message.
This messages means that an high PRESSURE block of the machine occurred, and then the pumps has
been switched off as safety procedure. In this case is suggested to perform a reset procedure checking
again the functioning of the unit.
•
SYSTEM BLOCKED
Push STOP to acknowledge the message.
This messages means that an hydraulic block of the machine occurred, and then the pumps has been
switched off as safety procedure. In this case is suggested to perform a reset procedure and investigate on
the possible hydraulic origins of the problem. If the origin of the problem is just a malfunctioning of the signal
pressure switch, it is possible to start again the unit, activating the bypass.
•
BYPASS WARNING
This message advice or remember that the unit is working in bypass mode (then some safety functions are
disabled).
•
CHANGE PUMP FILTERS
THE PRESENT MANUAL BELONGS TO -
Schenker Italia
- ALL RIGHTS RESERVED
33
COD.
80S12/24.D.2018
EN
Advertisement
Table of Contents
