Settings Related To Waiting Time - Fujitsu fi-600F Operator's Manual

Chapter 7 Operational Settings

7.5 Settings Related to Waiting Time

Waiting Time to Enter Power Saving Mode [Power
saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to "7.1 Starting Up the Software Operation Panel"
(page 58).
2
From the listing on the left, select [Device Setting].
3
Use the slider to specify the waiting time before entering
power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
HINT
Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8 Hours].
TOP
Contents
Index
Introduction
Scanner
Overview
How to Scan
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Appendix
Glossary
69