Welch Allyn 300 Series Directions For Use Manual page 27

Directions for Use
MAP measurement enable and disable
Default setting: MAP ENABLED for neonate; MAP DISABLED for adult and pediatric.
1. Depress
2. Press
display window.
3. Press
Note
4. To select the displayed state and return to normal operation, either do nothing for 10
seconds or press any button other than
as
For information about MAP measurements, see
for 3 seconds. SET HOUR XX appears in the message window.
repeatedly until MAP ENABLED or MAP DISABLED appears in the
mmHg
SYS SpO %
2
DIA
MAP DISABLED
or to enable or disable MAP measurement.
If you change the MAP enabled/disabled setting, refer to
patient type affects MAP defaults"
), the monitor returns to normal operation with that function (
mmHg
SYS SpO %
2
DIA
MAP ENABLED
/min
ºF ºF
on page 34.
or . If you press a function button (such
/min
ºF ºF
"Patient monitoring"
Chapter 2 Setup 23
"How changing the
) activated.
on page 29.