Troubleshooting; Anti-Hunting; Messages (Code Type Bxx Or Mxx) - DeDietrich Innovens MCA 25 BIC User Manual

MCA 25/28 BIC
6

Troubleshooting

6.1

Anti-hunting

6.2

Messages (Code type Bxx or Mxx)

Code Messages
B00 BL.CRC.PSU
B01 BL.MAX BOILER
B02 BL.HEATING SPEED
B07 BL.DT OUTL RET.
15/06/12 - 300022162-001-01
When the boiler is in Anti-short-cycle operating mode, the symbol ?
flashes.
1. Press the "?" key.
The message Operation assured when the restart temperature
will be reached is displayed.
In the case of failure, the control panel displays a message and a
corresponding code.
1. Make a note of the code displayed.
The code is important for the correct and rapid diagnosis of the
type of failure and for any technical assistance that may be
needed.
2. Switch the boiler off and switch back on.
The boiler starts up again automatically when the reason for the
blocking has been removed.
3. If the code is displayed again, correct the problem by following the
instructions in the table below:
Description
The PSU PCB is incorrectly
configured
Maximum flow temperature
exceeded
The increase in flow temperature
has exceeded its maximum limit
Maximum difference between
the flow and return temperature
exceeded
This message is not an error message but an item of
information.
Checking / solution
Parameter error on the PSU PCB
Contact the professional who takes care of
4
maintenance of the appliance
The water flow in the installation is insufficient
Check the circulation (direction, pump, valves)
4
The water flow in the installation is insufficient
Check the circulation (direction, pump, valves)
4
Check the water pressure
4
Sensor error
Contact the professional who takes care of
4
maintenance of the appliance
The water flow in the installation is insufficient
Check the circulation (direction, pump, valves)
4
Check the water pressure
4
Sensor error
Contact the professional who takes care of
4
maintenance of the appliance
6. Troubleshooting
32