Adjusting The Anti-Scalp Rollers - Toro TITAN ZX4800 Operator's Manual

Figure 23
1. Deck lift pedal
2. Handle
g024410
3. Height-of-cut positions
4. Pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade control switch (PTO), move
the motion control levers to the neutral lock
position and set the parking brake.
2. Stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the flange nut, anti-scalp roller and bolt
from the bracket
Note:
Keep the bolt and anti-scalp roller
together when removing.
1. Flange Nut
2. Spacer
3. Anti-scalp roller
4. Align the bolt and anti-scalp roller in the hole of
the bracket that matched the closest height of
cut position (Figure
5. Insert the bolt into the bracket hole and secure
the bolt and anti-scalp roller with the flange nut
(Figure 24).
24
(Figure 24).
Figure 24
4. Bushing
5. Bolt
24).
g024312