Removing The Mower - Toro TITAN ZX4800 Operator's Manual

1. Spring removal tool (Toro
part no. 92-5771)
2. Idler spring
3. Deck post
7. Lower the mower to the lowest height-of-cut.
8. Place the height-of-cut pin in the lock position
for lowest height-of-cut.
9. Remove the belt from the mower deck pulleys
and remove the existing belt.
Installing the Belt
1. Install the new belt around the mower pulleys
and the clutch pulley under the engine
66).
2. Using a spring removal tool (Toro part no.
92-5771), install the idler spring over the deck
post and place tension on the idler pulley and
mower belt (Figure
3. Ensure that the belt is properly seated in all
pulleys.
4. Install the belt covers
Figure 66
4. Idler arm
5. Mower belt
66).
(Figure 67).
g020312
1. Position the belt cover and
ensure that the tabs seat.
2. Pivot the belt cover down

Removing the Mower

Park the machine on a level surface and disengage
the blade control switch. Move the motion control
levers outward to the neutral position, engage parking
brake, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
(Figure
Lower the mower to the lowest height-of-cut. Select
one of the following procedures depending on the
mower deck size installed to complete the removal.
Preparing to Remove the Mower
Deck
1. Lower the mower to the 76 mm (3 inch)
height-of-cut position.
2. Remove the mower belt from the engine pulley;
refer to
49
Figure 67
3. Tighten the screws
Removing the Belt (page
g020313
48).