Positioning The Seat; Adjusting The Motion Control Levers; Pushing The Machine By Hand - Toro TITAN ZX4800 Operator's Manual

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
Figure 25
Adjusting the Motion
Control Levers
Adjusting the Height
Note:
Repeat the adjustment for the opposite control
lever.
The motion control levers can be adjusted higher or
lower for maximum operator comfort
Figure 26
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1.
2.
3.
Pushing the Machine by
Hand
Important:
Never tow the machine because damage may
occur.
To Push the Machine
1.
g027632
2.
3.
(Figure 26).
g027252
To Operate the Machine
Move the bypass to the position for operating the
machine
25
Loosen the upper bolt holding the control lever
to the control arm shaft.
Loosen the lower bolt just enough to pivot the
control lever fore or aft. Tighten both bolts to
secure the control in the new position.
Repeat the adjustment for the opposite control
lever.
Always push the machine by hand.
Park the machine on a level surface and
disengage the blade control switch.
Move the motion control levers outward to
neutral lock position, stop the engine, remove
the key, and wait for all moving parts to stop
before leaving the operating position. Make sure
the parking brake is disengaged.
Do this procedure on each side of the
machineFigure 27.
Figure 27
(Figure 27) to engage the wheel motors.
g027642