Pre-Maintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro TITAN ZX4800 Operator's Manual

1. Read the Operator's Manual for information on maintenance.
2. Check the engine oil every 8 hours
3. Check the drive wheel tire pressure every 25 hours
Pre-Maintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the
neutral lock position. Lift the seat forward.
The following components can be accessed by raising
the seat:
•
Service decal
•
Fuses
•
Battery and cables
Figure 31
Located on the seat pan underside
4. Check the hydraulic oil every 25 hours
5. Check the caster wheel tire pressure every 25 hours
6. Lubricate the caster wheel every 25 hours

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all
Grease Type: No. 2 General Purpose Lithium Base
Grease
1.
2.
3.
31
lubrication points.
Park the machine on a level surface and
disengage the blade control switch.
Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, and wait for all moving parts to stop
before leaving the operating position.
Clean the grease fittings with a rag
and Figure 32). Make sure to scrape any paint
off of the front of the fitting(s).
decal130-6996
(Figure 31