Stopping The Machine; Adjusting The Height-Of-Cut - Toro TITAN ZX4800 Operator's Manual

Figure 21

Stopping the Machine

CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
To stop the machine, move the traction control levers
to neutral and move to locked position, disengage the
blade control switch (PTO), move the throttle between
the half and full position, and turn the ignition key to
off.
Set the parking brake when you leave the machine;
refer to Setting the Parking Brake (page
Remember to remove the key from the ignition switch.

Adjusting the Height-of-Cut

The machine is equipped with a foot pedal deck lift
system. The operator can use the foot pedal to lift
the deck briefly to avoid obstacles or lock the deck in
the highest height-of-cut or transport position. The
operator can use the height of cut lever with the foot
pedal to lock the deck in a specific cutting height.
Using the Foot Pedal Deck Lift
System
•
Press the pedal down to raise the deck; continue
to press the pedal until the deck is locked in the
transport position
•
Push on the deck lift pedal with your foot and pull
the transport lock handle rearward to disengage
the transport lock
g008953
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 114 mm
(1-1/2 to 4-1/2 inch) in 6 mm (1/4 inch) increments
by relocating the height-of-cut pin into different hole
locations.
1. Push on the deck lift pedal with your foot and
19).
raise the mower deck to the transport lock
position (also the 114 mm (4-1/2 inch) cutting
height position)
2. To adjust, remove the pin from the height-of-cut
bracket
3. Select a hole in the height-of-cut system
corresponding to the height-of-cut desired and
insert the pin
4. Push on the deck lift pedal with your foot and pull
the handle rearward to disengage the transport
lock
5. Lower the deck slowly until the lever makes
contact with the pin.
23
(Figure 22).
(Figure 22).
Figure 22
Transport Lock Position
(Figure 23).
(Figure 23).
(Figure 23).
(Figure 22).
g024409