Installing The Mower Deck - Toro TITAN ZX4800 Operator's Manual

Removing the Mower Deck
1. Remove the hair pin cotter and washer securing
the long, link pin to the frame and deck; remove
the link bar (Figure
Figure 68
1. Link pin
2. Washer
2. Lift up on the mower deck to relieve tension from
the mower deck.
3. Remove the chains from the hooks on the deck
lift arms (Figure 69).
Figure 69
1. Deck lift arm
2. Chain
4. Raise the height-of-cut to the transport position.
5. Remove the belt from the clutch pulley on the
engine.
6. Slide the mower out from underneath the
machine.
Note:
Retain all parts for future installation.
68).
3. Hair pin cotter
3. Hook
4. Adjustment bolt

Installing the Mower Deck

1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, set the parking brake and wait for
all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Place the height-of-cut pin in the lock position
for lowest height-of-cut.
g024314
6. Lift the rear of the mower deck and attach the
chains to the rear lift arms
7. Attach the front chains to the front lift arms
(Figure 69).
8. Install the long, link bar through the frame
hanger and deck.
9. Secure the link pin with the hair pin cotters and
washers removed previously
10. Install the mower belt onto the engine pulley;
refer to Installing the Belt (page
g024313
50
(Figure 69).
(Figure 68).
49).