Menu Functions - STIEBEL ELTRON PSH 30 Universal EL Operation And Installation

Operation
Settings
4.4

Menu functions

4.4.1 General menu settings principle
Note
Your settings are retained even after disconnection from
the power supply.
When carrying out menu settings, if you do not make any
entry for 15 seconds, the set temperature is displayed
again. You setting is not saved.
f Call up all menu functions one after f
the other using the mode button.
The symbol for the current menu function
appears. The heat-up symbol may light up,
but no other symbols are illuminated.
The current setting is displayed:
Function off
0
Function on
1
- [°C] for menu function temperature limit
40 60
To change the setting, proceed as follows for all menu functions:
f Switch on the menu function using the f
plus button or adjust the value.
f Switch off the menu function using the f
minus button or adjust the value.
f Confirm your setting using the OK f
button.
The current setting for the menu function
is saved. The set temperature is displayed.
4.4.2 Displaying the fault code
This menu function only appears when there is a fault and the
display flashes.
f Press the mode button. f
E...
If there is a fault and the display flashes, the
fault code (see chapter "Troubleshooting")
is displayed.
www.stiebel-eltron.com
4.4.3 Selecting energy saving mode
ECO Comfort (factory setting)
This energy saving mode always offers you the maximum amount
of hot water and therefore maximum comfort.
In ECO Comfort energy saving mode, the set temperature is auto-
matically reduced after a week from 85 °C to 60 °C.
In ECO Comfort energy saving mode, you can also adjust the set
temperature manually at any time between 61 °C and 70 °C. This
is also possible immediately after commissioning and after au-
tomatic reduction of the set temperature. If you select a set tem-
perature higher than 70 °C, the set temperature is automatically
reduced again after a week to 60 °C.
ECO Plus (with single circuit operation)
This energy saving mode offers you the advantage of energy sav-
ings, as heating is only carried out after considerable draw-off.
In ECO Plus mode, the appliance heats up automatically to the set
temperature of 60 °C once you have drawn off 40% of the water
heater content.
ECO Dynamic (with single circuit operation)
This energy saving mode offers you maximum energy efficiency
through intelligent dynamic matching to your draw-off behaviour.
When you select ECO Dynamic mode, the appliance evaluates your
draw-off times and quantities for a week. The next week, you have
the required mixed water volume available at the draw-off time.
The appliance monitors your user behaviour and automatically
adjusts the heat-up times as required.
This energy saving mode is optimal if you require hot water at
the same time during a week. If your draw-off times change, hot
water is available the next week at the new times.
The set temperature is set immediately to 60 °C.
Note
In commercial mode (see chapter "Commercial mode")
and in manual operating mode (see chapter "Appliance
description"), the ECO menu functions are skipped.
f Select the ECO Comfort menu function f
1
1
with the mode button.
The ECO Comfort symbol appears.
Note
You cannot select ECO Plus or ECO Dynamic energy sav-
ing mode if a temperature limit is switched on or reverse
control is enabled in dual circuit operation.
These menu functions are then skipped.
f Press the mode button again to select f
2
0
the ECO Plus menu function.
The ECO Plus symbol appears.
PSH Universal EL| 27