Other Symbols In This Documentation; Units Of Measurement; Safety; Intended Use - STIEBEL ELTRON PSH 30 Universal EL Operation And Installation

Operation

Safety

1.2

Other symbols in this documentation

Note
General information is identified by the symbol shown
on the left.
f Read these texts carefully. f
Symbol Meaning
Material damage
!
(Appliance and consequential losses, environmental pol-
lution)
Appliance disposal
f This symbol indicates that you have to do something. The ac- f
tion you need to take is described step by step.
1.3

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
24 | PSH Universal EL
2. Safety
2.1

Intended use

The appliance is intended for heating domestic hot water and can
supply one or more draw-off points.
This appliance is designed for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-
domestic environment, e.g. in a small business, as long as it is
used in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. It is not permissible to heat other liquids or materials. Obser-
vation of these instructions and of instructions for any accessories
used is also part of the correct use of this appliance.
2.2

Safety instructions

WARNING Burns
During operation, the tap and safety assembly can reach
temperatures in excess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 8 and up
and persons with reduced physical, sensory or mental
capabilities or a lack of experience provided that they
are supervised or they have been instructed on how to
use the appliance safely and have understood the result-
ing risks. Children must never play with the appliance.
Children must never clean the appliance or perform user
maintenance unless they are supervised.
Material damage
!
Protect the water lines and the safety assembly against
frost.
Note
The appliance is under pressure. During the heat-up
process, expansion water will drip from the safety valve.
If water continues to drip when the heat-up process is
completed, and if the water pressure is lower than 0.6
MPa, please inform your heating contractor.
2.3

Test symbols

See type plate on the appliance.
www.stiebel-eltron.com