Chroma Studio Force V Phosphor User Manual page 13

Setup Menu
Studio Force V Phosphor User Manual
1. On the Main Menu, tap Change Mode.
2. On the Change Mode screen, tap Look Sel.
3. Tap Apply to save or Escape to cancel.
4. Scroll through the Looks using the assigned channel on the external DMX console
which is connected to the fixture. Access to the 32 stored Looks corresponds to the
channel level from 0% to 100%.
LookStore
In this mode, Looks created from an external DMX console can be captured and stored in the
internal memory of the fixture.
To capture a Look,
1. On the Main Menu, tap Change Mode.
2. On the Change Mode screen, tap KHL. The Look Store button appears only when KHL
is the assigned mode.
3. Create your Looks through the external DMX console using the assigned KHL channels.
4. On the Change Mode screen, tap Look Store.
5. On the Look Store screen, tap the up or down arrows to select which Look number to
store the created Look.
6. Then tap CaptureDMX CaptureDMX to assign the Look number. CaptureDMX CaptureDMX
7. Repeat steps 3 to 6 to create and capture other Looks.
To save all the captured Looks,
8. Press and hold SaveLooks, then follow the text prompt which appears on the screen -
>Hold SaveLooks, then >Looks Saved. . . .
The screen goes back to the Main Menu after 30 seconds or you may tap the Escape button to
go to the Main Menu.
Slave
In this mode, the fixture is set as the slave unit when connected to other units. The settings of
the master unit will be automatically applied to all the slave units.
To set the fixture as the slave unit,
1. On the Main Menu, tap Change Mode.
2. On the Change Mode screen, tap Slave, and then tap Apply.
The screen goes back to the Main Menu showing Mode: Slave.
Manual/Mstr
In this mode, the fixture is set as the Master standalone unit. Kelvin (color temperature), Hue
and Level (intensity) are set in the Manual Mode Settings screen. (See Manual Mode Setting
below.)
To access Manual/Mstr mode,
1. From the Main Menu, tap Change Mode.
2. From the Change Mode screen, tap Manual/Mstr, and then tap Apply.
The screen goes back to the Main Menu showing Mode: Manual and fixture output goes to the
manual settings set previously.
Go back to the Main Menu and tap Manual to access the Manual Mode settings.
www.chroma-q.com
12 V1.5 December 2014