Installation Of The Optional Wine Guardian Remote Sensor; Mounting The Remote Sensor - Wine Guardian TTW009 Installation, Operation And Maintenance Manual

Installation of the Optional Wine Guardian Remote
Sensor
The Remote Sensor is a combination temperature and humidity sensor only. It
is designed to be mounted within the wine cellar and can be used in
combination with Local Interface Controller or the Remote Interface
Controller and up to two additional Remote Sensors to control multiple areas
within the wine cellar.
Note: The Remote Sensor and Remote Interface Controller are now only
available in black

Mounting the Remote Sensor

Fig.1
Fig.1
Fig, 2
33
1. Disconnect the communication cable from the back the
remote sensor. Install the communication cable within
the wall and/or ceiling structure of the wine cellar to the
desired controller mounting location.
2.
A splitter device has been supplied within the Remote
Sensor kit. The splitter device must be mounted at the
WG unit. DO NOT mount the splitter device at the back
of the Remote Interface Controller or to the back of the
Remote Sensor as this WILL cause component or system
damage.
2. Mount the Remote Sensor on a solid surface away from
doors, corners, air outlets, drafts or heat generating
equipment. Do not mount the Remote Sensor directly on
an outside wall or wall adjacent to a boiler room. Use a
piece of foam insulation behind the sensor to insulate it
from a hot or cold surface. The recommended height is
4 to 5 feet (1.2 to 1.5 meters) above the finished floor.
3. Remove the sensor cover plate by removing the two
allen head screws at the top of the cover using the allen
head wrench provided in the kit. (Fig.2) Mark the
mounting points at the desired location within the wine
cellar. Also mark the location of the communication
cable connection as this area will require sufficient
clearance, for instance 1½" (3.8cm) hole in the wall for
flush mounting of the sensor plate.
Important