Installing The Thermostat And Communication Cable; Mounting The Optional Remote Interface Controller - Wine Guardian TTW009 Installation, Operation And Maintenance Manual

Installing the Thermostat and Communication Cable

Local Interface Controller
However, sometimes multiple points of sensing and control are ideal, especially for odd shaped
rooms.
Optional Remote Interface

Mounting the Optional Remote Interface Controller

Fig. 1
31
The Wine Guardian Local Interface Controller is a
combination temperature and humidity controller with single
stage cooling, heating and humidifier control. Each Wine
Guardian Through-the-Wall unit is supplied with a Local
Interface Controller as an integral component of its assembly.
It is installed at the factory and tested prior to shipment.
In most applications, the Local Interface Controller is
adequate for proper wine cellar monitoring and control.
Wine Guardian Remote Sensors offer the ability to sense a
maximum of three locations and control to their average
condition.
Wine Guardian also offers the option of monitoring the wine
cellar conditions from outside of the wine cellar or from
another room in the home or building, through the use of the
Remote Interface Controller. (Optimal temperature 55
Degrees F or 13 Degrees C)
1. Disconnect the communication cable from the
back of Remote Interface Controller. (Fig. 1)
a). Install the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b). Mount the remote interface controller on a
solid surface away from doors, corners, air
outlets, drafts or heat generating equipment. Do
not mount the Remote Interface Controller
directly on an outside wall or wall adjacent to a
boiler room