Installing The Condensate Overflow - Wine Guardian TTW009 Installation, Operation And Maintenance Manual

Step 4
Step 5
Step 6

Installing the Condensate Overflow

Condensate generation is a natural by-product of air conditioning systems. The Wine Guardian
cooling coils are designed with the understanding that optimal wine cellar humidity levels are
between 55% RH and 60% RH. If the vapor barrier of the wine cellar is poorly constructed or
excessive moisture is in the basement or surrounding areas, then the cooling coil may generate
excessive amounts of moisture. The condensate will appear in the form of water at the cooling
coil drain pan and eventually will travel to the condensate removal system located below the
compressor. The Wine Guardian system features an auxiliary drainport connection located at the
condenser end of the system directly below the plastic face plate
28
Insert screws into upper pre-drilled hole on both sides of sleeve, continue to
lower set of holes. Ensure screws are flush with wall sleeve. Do not over
tighten.
Slide the Wine Guardian Through-the-Wall system through the
EasyMount™ sleeve to the desired depth. Please note the Through-the-
Wall system must be slid so that the power cord side is last, not first, to
enter the sleeve. Do not slide the system past the desired flush mounting
point.
Seal joint between EasyMount™ sleeve and Wine Guardian system on the
flange side of system with a latex caulk to ensure a tight seal and prevent
the system from horizontal movement. After caulking add the kit supplied
self-adhesive insulate strips tight to the chassis and cover the wall sleeve
flanges to prevent possible sweating.