Accessories And Optional Equipment; Installation Sleeve; Extended Compressor Warranty; Duct Collar Adapter - Wine Guardian TTW009 Installation, Operation And Maintenance Manual

Accessories and Optional Equipment

Installation Sleeve

Each Wine Guardian system includes an EasyMount™ installation sleeve to be used in the
mounting of the system through-the-wall at the desired location. The sleeve is essential for the
proper support of the Wine Guardian system and ease of installation. The maximum dimensions
of the wall opening should be 14½" wide by 16¼" high (36.83cm wide by 41.28cm high).
For proper operation of the system, including drainage and undue noise and vibration, the
Installation Sleeve must be mounted level within the wall cutout and securely fastened to the
wall studs on either side of the sleeve as shown on page 27.
Extended Compressor Warranty---U.S. and Canada only
The Wine Guardian uses only the best commercially available compressors on the market.
However, since the compressor is the single most expensive component in the system, it is
recommended that you purchase the extended, five-year warranty option.

Duct Collar Adapter

An optional duct collar kit is available for ease in directing the warm condenser air away from
the through-the-wall unit mounting. The kit includes one (1) duct collar, 15-feet (4.5 meters) of
6-inches (15.24cm) round flexible ductwork and two (2) tie wraps for connection of the
ductwork to the duct collar. The kit does not include connections at the tie-in point to the remote
location or outdoors.

Remote Temperature/Humidity Controller

The remote temperature/humidity controller (Remote Interface Controller) is intended to provide
a means for user interface at a remote location. The controller can be used as a remote
sensor/controller mounted within the wine cellar remote from the Through-the-Wall system. The
controller can also be used as a remote indicator (without sensor) mounted directly outside of the
wine cellar of the residence or building. The Remote Interface Controller includes a backlit face
for temperature and humidity indication along with controller set-up and operational functions.

Remote Temperature/Humidity Sensor

The remote temperature/humidity sensor is intended to provide a means of sensing one or more
locations within the wine cellar and designed to work in conjunction with the Remote Interface
Controller or Local Interface Controller integral to the Wine Guardian Through-the-Wall system.
Multiple sensor readings are averaged and controlled to a single point. The sensors do not have
any temperature or humidity indication and must be mounted within the wine cellar.

Heater Option

The electric heat option includes an integral electric heating element, thermal overload protection
device and controls. The Wine Guardian will either cool or heat the air, but it is not designed to
do both at the same time. The Wine Guardian electric heat option must be specified at time of
order and installed at our factory.
10