Processor And Heatsink Installation - Supero A+ SERVER 1022G-NTF User Manual

A R
+ SE VER 1022G-NTF User's Manual
5-5

Processor and Heatsink Installation

When handling the processor, avoid placing direct pressure on the label
area of the fan. Also, do not place the serverboard on a conductive
!
surface, which can damage the BIOS battery and prevent the system
from booting up.
Notes:
•
Always connect the power cord last and always remove it before adding, re-
moving or changing any hardware components. Make sure that you install the
processor into the CPU socket before you install the CPU heatsink.
•
If you buy a CPU separately, make sure that you use an Intel-certifi ed multi-
directional heatsink only.
•
Make sure to install the serverboard into the chassis before you install the CPU
heatsinks.
•
When receiving a serverboard without a processor pre-installed, make sure that
the plastic CPU socket cap is in place and none of the socket pins are bent;
otherwise, contact your retailer immediately.
•
Refer to the Supermicro web site for updates on CPU support.
Installing the Processors
1. Begin by removing the cover plate that
protects the CPU. Lift the lever on the
CPU socket until it points straight up.
2. With the lever raised, lift open the silver
CPU retention plate.
5-2