Using The Adaptec Raid Utility; Installing The Raid Driver During Os Installation - Supero A+ SERVER 1022G-NTF User Manual

1. After exiting the BIOS Setup Utility, the system will reboot. When prompted
during the startup, press the <CTRL+A> key when prompted to run the Dot-
Hill RAID Utility program (see Figure 5-6).
Figure 5-6.Adaptec RAID Utility Program Screen

Using the Adaptec RAID Utility

The Adaptec® RAID Utility program is where you can defi ne the drives you want
to include in the RAID array and the mode and type of RAID.

Installing the RAID Driver During OS Installation

You may also use the procedure below to install the RAID driver during the Win-
dow's OS installation:
1. With the Windows OS installation CD in the CD-ROM drive, restart the sys-
tem.
2. When you see the prompt, hit the <F6> key to enter Windows setup.
3. Eventually a blue screen will appear with a message that begins "Windows
could not determine the type of one or more storage devices . . ." When you
see the screen, hit the <S> key to "Specify Additional Device", then insert the
driver diskette you just created into the fl oppy drive.
4. Highlight "Manufuacturer Supplied Hardware Support Disk" and hit the <En-
ter> key.
Chapter 5: Advanced Serverboard Setup
5-25