A
R
+ SE
VER 1022G-NTF User's Manual
Unit Identifi er Button
In addition to the UID (Unit Identifi er) button
on the rear I/O panel, there is another UID
button located on the control panel. When
you push either UID button, both Rear UID
and Front Panel UID Indicators will illumi-
nate. Push either button again to turn off
both indicators. These UID indicators provide
easy identifi cation of a system unit that may
be in need of service.
IPMB
A System Management Bus header for the
IPMI slot is located at IPMB. Connect the
appropriate cable here to use the IPMB I2C
connection on your system.
Video Connector
A Video (VGA) connector is located below
the COM Port on the IO backplane. This
connector is used to provide video and CRT
display.
Compact Flash Card PWR Connector
A Compact Flash Card Power Connector
is located at JWF1. For the Compact Flash
Card to work properly, you will need to en-
able with JCF1 and connect a Compact Flash
Card power cable to JWF1 fi rst.
Pin#
1
2
3
4
Pin#
1
2
3
4
5-18
UID Button
Pin Defi nitions
Defi nition
Ground
Ground
Button In
Ground
IPMB
Pin Defi nitions
Defi nition
Data
Ground
Clock
No Connection