Yaesu FTDX5000 Series Operating Manual page 24

F P
RONT ANEL
[ A ] , [ B ] Switches
Pressing the [ A ] or [ B ] button will illuminate the re-
spective switch, and allow adjustment of the major
functions (such as mode and band selection etc) on the
VFO-A or VFO-B receiver. Usually, the [ A ] button will
glow red, and the VFO-A functions may be adjusted.
Similarly, pressing the [ B ] button will cause its indica-
tor glow orange, signifying the VFO-B functions may
be adjusted.
A :
DVICE
The [ A ] / [ B ] switches affect the following functions:
 [ RX ANT ] switch
 [ ANT 1-4 ] switch
 [ ATT ] switch
 [ IPO ] switch
 [ R.FLT ] switch
 [ AGC ] switch
 [ NAR ] switch
 [ BAND ] switches
 [ MODE ] switches
 [ NB ] switch
 [ RX ANT ] switch
Page 22
C
ONTROLS
& S
WITCHES
QMB ( Quick Memory Bank ) Switches
[ STO ] ( Store ) Button
Pressing this button, copies the operating informa-
tion for frequency, mode, and bandwidth, into con-
secutive QMB Memories. Repeater shift/direction,
frequency and CTCSS functions, are also copied
in the FM mode.
[ RCL ] ( Recall ) Button
Pressing this button recalls one of the five Quick
Memory Bank memories for operation.
[ NAR ] ( Narrow ) Switch
This button is used to set the DSP (digital) filters to
narrow bandwidths. The default values are as follows:
NAR S
MODE
OFF
2.4 kHz

LSB/USB
( 1.8 kHz - 4.0 kHz / 16 steps )
2.4 kHz

CW
( 500 Hz - 2.4 kHz / 7 steps )
RTTY 500 Hz

( LSB ) ( 500 Hz - 2.4 kHz / 7 steps )
PKT 500 Hz

( LSB/USB ) ( 500 Hz - 2.4 kHz / 7 steps )
PKT 25 kHz
( FM ) (± 5.0 kHz Deviation )
AM 9 kHz
25 kHz
FM
(± 5.0 kHz Deviation )
 : You may enable the [ WIDTH ] knob to adjust the
bandwidth.
FT 5000 O
DX
WITCH
ON
1.8 kHz

( 200 Hz - 1.8 kHz / 9 steps )
500 Hz

( 50 Hz - 500 Hz / 10 steps )
300 Hz

( 50 Hz - 500 Hz / 10 steps )
300 Hz

( 50 Hz - 500 Hz / 10 steps )
12.5 kHz
( ±2.5 kHz Deviation )
6 kHz
12.5 kHz
( ±2.5 kHz Deviation )
M
PERATING ANUAL