Qmb (Quick Memory Bank) - Yaesu FTDX5000 Series Operating Manual

The Quick Memory Bank consists of five memories (labeled "C-1
memories. These can quickly store operating parameters for later recall.
QMB Channel Storage
1. Tune to the desired frequency on VFO-A.
2. Press the blue [ STO ] button briefly. The
"beep" will confirm that the contents of
VFO-A have been written to the currently
available QMB memory.
3 If you repeatedly press the [ STO ] button, the QMB
memories will be written in the following order:
C-2  C-3 C-3  C-4 C-4  C-5 C-5  C-1
C-2 C-2 C-3 C-3 C-4 C-4 C-5 C-5
C-2 C-2 C-3 C-4 C-5
Once all five QMB memories have data in them, previous
data (starting with channel "C-1
a first-in, first-out basis.
QMB Channel Recall
1. Press the blue [ RCL ] button briefly. The
current QMB channel data will be shown
on the VFO-A frequency display field,
and the QMB memory channel num-
ber will appear in the small window at
the lower right corner of the display.
2. Repeatedly pressing the [ RCL ] button will rotate
through the QMB channels:
C-2  C-3 C-3  C-4 C-4  C-5
C-2 C-2 C-2 C-2 C-3 C-3 C-3 C-4 C-4 C-4
3. Press the [ V/M ] button briefly, to return to the VFO or
Memory mode.
A :
DVICE
Rotating the Main Tuning Dial knob, or changing the op-
erating mode will place the transceiver in the "Memory
Tune" mode. This is a temporary "pseudo-VFO" method
of tuning off of a stored memory channel. If you do not
over-write the contents of the current memory channel,
the original contents will not be disturbed by the initiation
of Memory Tune operation.
FT 5000 O
DX PERATING
QMB ( Q
UICK
C-1 ......
C-1 C-1
C-1
C-1 C-1 C-1") will be over-written, on
C-1
C-1 ......
C-5  C-1
C-5 C-5 C-5 C-1 C-1 C-1
M
ANUAL
M
EMORY
)
M B
EMORY ANK
C-1 C-1 C-5 C-5
C-1" through "C-5 C-1 C-5.") independent from the regular and PMS C-5
O
PERATION
[ STO ] Button
[ RCL ] Button
[ V/M ] Button
Page 101