Running The Self Test - Fargo Persona Persona C30e User Manual

RESTRICTED USE ONLY

Running the Self Test

Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has
been conducted or (c) a part has been replaced to check for proper Printer operation.
Step Procedure
1 Verify that a full-color or Premium Resin Ribbon Cartridge is installed and that
cards are properly loaded.
Caution: If the power is ON, disconnect the Power Cable from the
Printer's rear panel.
2 Press and hold the Pause/Resume button.
3 While holding down the Pause/Resume button, plug the power cable back into
the Printer.
•
4
Full Color Ribbon Cartridge installed: The Printer will print a 3-color
process gray scale on the front of the card. The overlay pass is not printed
during the Self-test. (See Display A below)
•
Premium Resin Ribbon Cartridge installed: The Printer will print a
single color gray scale on the front of the card.
Persona C30e Card Printer User Guide (Rev. 1.1)
Fargo Electronics, Inc.
4-54