Table of Contents
Advertisement
12 May 2005
Operation
Once the display has gone through the startup cycle it should end up with the
PYRO *
TURBO
TRANS
*
This value based on a pyrometer probe mounted post-turbo.
These are only suggested settings and will vary depending on vehicle condition,
performance enhancements and driving techniques.
NOTES: All temperature readings are in Fahrenheit (
per-square-inch (PSI) and fuel level is displayed in percentages. All readings are
approximate and may vary due to characteristics of sensor, sender or probe, and,
certain conditions can cause interference or sway reading.
The alarm settings for fuel pressure (F-PSI), oil pressure (O-PSI) and fuel level
(FUEL) are for will display an alarm with the measurement drops below the set
value; all other measurements will alarm when the value is above the setting. The
history value also works the same where it records the lowest achieved value on F-
PSI, O-PSI and FUEL and the highest value on all others.
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295
1086210 GMC/Chevy Duramax X-Monitor
RECOMMENDED ALARM SETTINGS:
900°F *
25
200
OIL
Dependant On Location of Sender
User Defined – Consult Exhaust Brake
B-PSI
Manual for safe ranges
F-PSI
3
FUEL
25
Plant Address: Unit A10, 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Phone: 604-853-6096 Fax: 604-853-8749 Internet: www.bd-power.com
following, default display.
To change the settings and set
alarm values there are 2 buttons
on the side of the display, the
bottom (MENU) button cycles
through the different modes and
the
controls the setting of the values.
BD Engine Brake Inc.
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
upper
(MODIFY)
°
F), pressures are in pounds-
20
button
Advertisement
Table of Contents
