Table of Contents
Advertisement
5/11/2006
1081100 Cool Engine Shutdown
Page 13
Temperature Adjustments
The shutdown temperature can be set by using a small flat-head screw driver to adjust
the potentiometer that can be accessed through the hole on top of the CES module
with the markings "550", "400" and "250".
By turning the screw clockwise until the potentiometer stops the CES will shutdown at
approximately 550°F; by turning all the way counter clockwise the CES will shutdown
at approximately 250°F. The markings are a general guide as to what the approximate
setting will be; the CES may have to be adjusted a few times until the desired
shutdown temperature is achieved.
Communication / Operation Lights
Through the translucent blue case of the CES module, there will be a Green and Red
LED visible during the operation of the CES. The Green LED will blink when the CES
senses communication between the X Monitor display and module. The Red LED will
light up when the exhaust temperature is above the shutdown temperature setting.
Mounting
Once all the wiring and adjusting has been performed, secure or mount the CES
module so that it is not interfering with feet and moving parts or near direct heat. Some
examples are to use Velcro to mount to the firewall or to the back of the X Monitor
module. Being that the CES module is light, it can be suspended if the wiring is
secure.
Optional LED Alarm
For those who wish to use an LED for the alarm instead of, or, in conjunction with the
audible alarm, the CES module can control the grounding of a LED through the "Aux
Output" terminal. This terminal could be used to control the grounding of other devices
but is only rated to a maximum of 0.5 amps; exceeding this rating will void the
warranty.
To mount the LED, drill a 0.250" hole in the desired location. From the front, push the
bezel into the hole you just drilled. From the backside, push the LED into the bezel
until it clicks into place, the flange at the base of the LED will be inside the bezel and
the LED will protrude by about 1/8" out the front of the bezel. Push the collar up the
wires and over the bezel/LED until it securely clicks into place.
Run the wires down to the CES and X Monitor modules keeping them from interfering
with moving or heated parts. With the black wire trim any excess, strip the end and
BD Engine Brake Inc.
Plant Address: Unit A10, 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
Phone: 604-853-6096 Fax: 604-853-8749 Internet: www.bd-power.com
Advertisement
Table of Contents
