Engine Oil Pressure Sensor; 2001-02 Duramax - BD Diesel Performance BD-Power X-MONITOR Installation Manual

12 May 2005

Engine Oil Pressure Sensor

2001-02 Duramax

wire to the 'DO NOT USE' terminal on the control box. That's right, this wire goes to
the 'DO NOT USE' terminal (this should have been labeled 'Future Expansion').
Secure the green wire in place away from any moving and/or hot parts and install
the skid plate that was removed in the first step. Tighten all fastening bolts. See
page 13 for the wiring diagram.
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295
1086210 GMC/Chevy Duramax X-Monitor
Plant Address: Unit A10, 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Phone: 604-853-6096 Fax: 604-853-8749 Internet: www.bd-power.com
Remove the front skid plate from
the bottom of engine and locate
the oil pressure-sending unit on
left side of engine block by the
steering box.
This sensor has only one (1)
wire attached.
Install a gray Posi-Tap onto the
tan w/white tracer wire of the
sensor then insert one end of the
green wire from the oil pressure
sensor kit to the gray Posi-Tap
and run the wire up into the cab.
Attach the other end of green
BD Engine Brake Inc.
U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
12