Exhaust Brake Pressure Sensor - BD Diesel Performance BD-Power X-MONITOR Installation Manual

12 May 2005 1086210 GMC/Chevy Duramax X-Monitor 10

Exhaust Brake Pressure Sensor

Install the supplied stainless steel line and fitting into the test port of the exhaust
brake. Secure the line and attach the plastic hose.
Route the hose up along the vehicle frame and into the cab then attach the hose to
the interface filter and connect the wires as per the "Back Pressure" diagram that will
follow after this section.
Use the following diagram/photo as a guide. Install the filter and tubing together and
insert onto the inlet of the RPS Module.
The plastic filter housing will need to be changed out after 6-12 months of use. This
time is dependant on air humidity and the amount moisture trapped in the actual
filter. The replacement filter part number is 1800135. This filter should be mounted
in an easy to access, visible location.
Because of the moisture accumulating in the line and filter, it is highly recommended
that the RPS unit be mounted at the highest point of the air line causing all the
moisture to run back down the line into the exhaust.
BD Engine Brake Inc.
Plant Address: Unit A10, 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295 U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
Phone: 604-853-6096 Fax: 604-853-8749 Internet: www.bd-power.com