Hollyland SOLIDCOM M1 User Manual page 16

GUIDE
⑥
Select "2 Wire" Entering 2 Wire Settings.
6.1 After connected to 2 Wire devices, set the corresponding wire length compensation
and terminal resistor of the station. Powe on the 2 Wire devices. Meanwhile the
microphone of 2 Wire devices needs to be turned off or disconnected to make sure there's
no other audio transmitting in the 2 Wire connection. Otherwise, the Auto Null will be
affected. Select "Auto Null", the station will complete the Auto Null operation of 2 Wire
Devices;
6.2 Select "Cable Compen", confirm the bus length of the same parallel 2 Wire Interface.
Select the corresponding compensation selection according to the bus length;
6.3 Select "Terminal Res", confirm whether the 2 Wire Device connected by the 2 Wire
interface has terminal resistor. The terminal resistor needs to switch to Off if the 2 Wire
Device has terminal resistor. The terminal resistor needs to switch to On if the 2 Wire
Device doesn't have terminal resistor.
6.4 Select "Input Gain" to enter input gain adjust menu, Select the corresponding level to
increase or decrease the corresponding value of the input signal;
6.5 Select "Output Gain" to enter output gain adjust menu, Select the corresponding level
to increase or decrease the corresponding value of the output signal.
⑦
Select "Reset" to Reset all the Adjusted Info of Station to Defaults.
⑧
Select "Info" to Check the Information of the Station.
14