Würth BLG 12-32 Showroom Operation Manual page 11

PREPARATION
Please note
Read the safety instructions before each use and
act accordingly. Incorrect installation may result in
personal injury and material damage. In you have
any questions, please contact a WÜRTH branch,
your WÜRTH sales representative or a WÜRTH­
authorised customer service centre.
First check the battery for internal and external
damage. Follow the manufacturer's instructions to
do this. If the battery is visibly damaged, it must
not be used. Replace it with a new battery. For
batteries which are not maintenance­free, check
that the electrolyte level is correct before charging.
If necessary, top up with distilled water. Clean the
terminals thoroughly before attaching the clips.
CONNECT THE CHARGER
First, connect the red + clip to the positive battery
terminal or the charging point specified by the
vehicle manufacturer. (see fig. D, page 3).
Connect the black ­ clip to a suitable ground
connection or the charging point specified by the
vehicle manufacturer. (see fig. D, page 3).
Connect the power cable to the mains. (see fig. E,
page 3).
AFTER CHARGING
Press the Off button and remove the black ­ clip first,
followed by the red + clip. Disconnect the power
cable from the mains. Roll up the cable carefully and
put the charger in a safe place.
MAINTENANCE
Before using the charger, ensure that all plug
connectors on both charger and the cables are
clean and dry. For the greatest possible safety, all
batteries should be checked at least once per month.
The charging process ensures that batteries remain
fully charged without using more water than is lost
through regular evaporation.
If an update to the charger software is required
in the future, this can be carried out using the micro­
USB port at the end of the charger (see fig. G,
page 3). The relevant information will be provided
with the software.
WARRANTY
We offer a warranty for this Würth charger from the
date of purchase in accordance with the statutory/
country­specific regulations (with invoice or delivery
note as proof).
A damaged machine is either repaired or replaced
with a substitute machine. Damage resulting from
improper handling is excluded from the warranty.
Complaints can only be accepted if the device is
handed over assembled to a Würth branch, your
Würth sales representative or a Würth­authorised
customer service centre.
Subject to technical change without notice.
We accept no liability for typographical errors.
DISPOSAL
Power tools, accessories and packaging
should be deposited at a recycling centre. EU
member states only: Do not dispose of your
power tool with domestic waste. In accordance
with EU Directive 2012/19/EU on waste electrical
and electronic equipment and the legislation
implementing it in national law, power tools which are
no longer serviceable must be separated and
deposited at a recycling centre.
11