(Pulley Assembly) Unpacking Instructions And Parts Identifi Cation - Fanimation Brewmaster FP10 Series Owner's Manual

Unpacking Instructions and Parts Identifi cation (cont'd)
FP10 (Short)/FP20 (Long) Pulley Assembly and Hardware Parts Identifi cation
FP10
Short Neck
Pulley
Assembly
Blade Holder
to Hub Screws
10-32 x ½˝ (5)
Lag Bolts (4) &
Flat Washers (4)
Traditional Blade
Screws, / ˝-24 x / ˝ (5)
3 3
16 8
NOTE: The illustration shown is not to scale or its actual confi guration may vary.
Parts and packings subject to change without notice.
NOTE: If you are uncertain of part description, refer to exploded
view illustration. (Figure 2, page 15)
FP20
Long Neck
Pulley
Assembly
Wood Blade Holders
(for use with FP1022, FP1026,
FP1030 blade sets)
Wood Blade Screws,
/ ˝-24 x ½˝ (7) &
3
16
Fiber Washers (7)
Figure 2
4
Traditional Blade Holders
(for use with Palm, Bamboo,
Belt
NOTE: Optional Wood Blade Holders (BH20 series) and B4000
wood blades are available for this assembly. Not for Damp
Location usage.
Wicker blade sets)
Phillips
Screwdriver