Pulley Assembly-Unpacking Instructions And Parts Identification - Fanimation Brewmaster FP10 Series Owner's Manual

Pulley Assembly-Unpacking Instructions and Parts Identification

FP10 (Short)/FP20 (Long) Pulley Assembly and Hardware Parts Identification
FP10
Short Neck
Pulley
Assembly
Blade Holder
to Hub Screws
10-32 x ½˝ (5)
Traditional Blade
Screws, / ˝-24 x / ˝ (5)
3 3
16 8
NOTE: The illustration shown is not to scale or its actual confi guration may vary.
Parts and packings subject to change without notice.
NOTE: If you are uncertain of part description, refer to exploded
view illustration. (Figure 2, page 17)
FP20
Long Neck
Pulley
Assembly
¼˝ x 2˝ Lag Bolts (4) &
Ø5 x Ø14x1mm
Flat Washers (4)
Wood Blade Screws,
Ø12.5 x Ø5x1 mm
Fiber Washers (7)
/ ˝-24 x ½˝ (7) &
3
16
Figure 2
NOTE: Optional Wood Blade Holders (BH20 series) and B4000
wood blades are available for this assembly. Not for Damp
Location usage.
5
Wood Blade Holders
(for use with FP1022, FP1026,
FP1030 blade sets)
Traditional Blade Holders
(for use with Palm, Bamboo,
Wicker blade sets)
Phillips
Screwdriver
Belt