How To Set Your Remote Receiver - Fanimation Brewmaster FP10 Series Owner's Manual

How to Set Your Switch Cap Remote Receiver
This step is to be completed prior to hanging your motor.
1. Removing the Switch Housing:
Remove the switch housing from the motor by
unscrewing the three screws and unplugging the
connector (Figures 1 & 2).
2. Removing the Receiver Unit:
Carefully, slide the remote Receiver from the Switch Cap
Housing, and locate the code switches on the underside
of the receiver unit (Figure 3).
3. Setting the Receiver Code:
The remote unit has 16 different code combinations.
It may be necessary to test a couple frequency code
settings to improve signal reception and/or eliminate
interference from other remote control household items.
Multiple fans should have different code settings to allow
independent fan control. To set the code, slide code
switches to the same positions as is set on your C20
transmitter (Figure 3).
4. Installing Receiver in Switch Cap Housing:
Slide remote Receiver into the Switch Cap, connect the
plug from the motor assembly into the socket located in
the receiver unit (Figure 2 & 3).
5. IMPORTANT - Brown Wire Connector:
On the Brewmaster motor, it requires the brown wire
to be UNPLUGGED FOR ONE FAN UNIT (Figure 4a),
or the brown wire to be PLUGGED IN FOR TWO FAN
UNITS (Figure 4b).
6. Installing the Switch Cap Housing:
Slide the assembled Switch Cap Housing over the Switch
Cap Base by installing and tightening the three screws
(Figure 1).
▲WARNING
Check to see that all connections are tight. To avoid
possible electrical shock, make sure that the electrical
wires are completely inside the switch housing and
not pinched between the switch cap base and switch
housing.
Figure 4a
6
Figure 1
Figure 2
Figure 3
Figure 4b