Unpacking Instructions - Fanimation Tropicana FP1600 Series Owner's Manual

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
•
One stepladder
•
One 1/4" blade screwdriver
•
WARNING
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 6). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
WARNING
Do not install or use fan if any part is damaged or
missing. Contact your retail store for missing or
damaged parts.
WARNING
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation
could result in personal injury or property damage.
1. Check to see that you have received the following
parts:
5-Blade Set
(Standard Oar shown)
NOTE: The illustration shown is not to scale or its actual configuration may vary.
Three wire connectors
•
(supplied)
One wire stripper /16"
•

Unpacking Instructions

Fan Motor
Assembly
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
NOTE: Place the parts from the loose parts bag in a small
container to keep them from being lost.
missing, contact your local retailer.
DAMP LOCATION CEILING FAN:
Ceiling Fan, you may only use light kits marked suitable for use
in damp locations.
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 18, Page 13)
• Fan Motor assembly
• Downrod/Hanger Ball assembly
• Ceiling Canopy & Hanger Bracket
− Canopy screws attached to hanger bracket
• Hardware bag:
− Ten 10-32 x 1/2" flywheel screws
− Two 8-32 x 1-1/2" machine screws
− Two flat washers
− Two lock washers
− Three wire connectors
− Two rubber pads
− Fanimation chain pull
• Motor Coupling Cover
• Set of blades (5), (Standard Oar or Narrow Oval)
Ceiling Canopy
Downrod/
Hanger Ball
Hanger Bracket
3
Wire Size A.W.G.
14
12
If any parts are
For a Damp Location
Motor Coupling Cover
Hardware Bag
(w/screws)