Table of Contents
Advertisement
6 Application
6.1 Using the product
WARNING
High energy! Risk of injury!
The light source transmits high-energy light that can lead to high surface temperatures. The
user or a third party may be startled if they come into contact with the hot light source and
then injure the patient by jerking the endoscope/fiberscope.
Do not touch the hot light source.
Only use the light source with an endoscope/fiberscope.
Always switch off the light source before putting it down, and never place it in the vicinity
of the patient.
WARNING
High energy! Risk of fire!
The light source transmits high-energy light that can lead to high surface temperatures.
Do not cover the light source with cloths or similar objects immediately after use.
WARNING
High light intensity! Danger of glare!
The high light intensity of the light source can permanently damage eyes and cause blindness.
Never look directly into the light outlet of the light source.
1.
Use the switch (On/Off) to switch the product on.
2.
Use the switch (On/Off) to switch the product off after use.
The LED flashes several times to signal the end of the battery service life. The flashing repeats
at 2-minute intervals until the battery is completely discharged after 5–10 minutes:
Model
11301D4
6.2 Activating and deactivating BOOST mode
The brightness can be increased in BOOST mode.
ü The product is switched on.
1.
To activate BOOST mode, press and hold the switch (On/Off).
ð The brightness is increased.
2.
To deactivate BOOST mode, press and hold the switch (On/Off) once again. BOOST
mode is then automatically deactivated after a certain amount of time.
ð The nominal brightness is reset.
Instructions for use • LED battery light source with fast screw thread • KCC914_EN_V1.0_11-2020_IFU_CE-
MDR
Operating time
Comment
2 h
–
2 batteries
–
Rechargeable batteries must not be
used.
Application
12
Hide quick links:
Advertisement
Table of Contents
