F32F Module; F32F Module - Extreme Networks BlackDiamond 6800 Hardware Installation Manual

All F32T ports use standard RJ-45 connectors and support 10BASE-T and 100BASE-TX.
The default configuration of the F32T module is as follows:
• All ports are added to the default VLAN as untagged.
• All ports inherit the properties of the default VLAN (protocol type, VLANid, and so
on).
• All ports are in auto-negotiation mode allowing 10 Mbps, 100 Mbps, full-duplex, or
half-duplex operation.
F32F M
ODULE
The F32F module, shown in
52020
Module status LEDs
1 9 17 25
2 10 18 26
3 11 19 27
Port status LEDs
4 12 20 28
5 13 21 29
6 14 22 30
7 15 23 31
8 16 24 32
AMBER = ACTIVITY
GREEN = LINK OK
FLASHING GREEN = DISABLED
1 17
4 20
5 21
100 Mbps
8 24
9 25
ports
12 28
13 29
16 32
Figure 1-7: F32F module
All F32F ports use standard MT-RJ connectors and support 100BASE-FX. The default
configuration of the F32F module is as follows:
• All ports are added to the default VLAN as untagged.
• All ports inherit the properties of the default VLAN (protocol type, VLANid, and so
on).
• All ports are in 100 Mbps, full-duplex mode.
B D H I
LACK IAMOND ARDWARE NSTALLATION
Figure 1-7, has 32 100 Mbps Ethernet ports.
BD_F32F
G
UIDE
B D 6800 C
LACK IAMOND OMPONENTS
1-15