Connections; Lithium Battery - Extreme Networks BlackDiamond 6800 Hardware Installation Manual

Denmark
Switzerland
• If the power cord plug is unsuitable and must be replaced, you may find other
codings for the respective connections. Connect the power supply wires for the unit
according to the following scheme:
— Brown wire to the Live (Line) plug terminal, which may be marked with the
letter "L" or colored red.
— Blue wire to the Neutral plug terminal, which may be marked with the letter "N"
or colored black.
— Yellow/Green wire to the Ground plug terminal, which may be marked with the
letter "E" or the Earth symbol
C
ONNECTIONS
• Fiber Optic ports - Optical Safety. Never look at the transmit LED/laser through a
magnifying device while it is powered on. Never look directly at the fiber TX port
and fiber cable ends when they are powered on.
• CLASS 1 LASER DEVICE
L
ITHIUM
• The battery in the bq4830/DS1644 device is encapsulated and not user-replaceable.
The battery is located on the MSM motherboard.
• If service personnel disregard the instructions and attempt to replace the
bq4830/DS1644, replace the lithium battery with the same or equivalent type, as
recommended by the manufacturer.
Caution: There is danger of personal injury and explosion if battery is improperly
discarded. Do not discard the battery in fire or near heat. Always dispose of used
batteries according to the battery manufacturer's instructions.
• Disposal requirements vary by country and by state.
• Lithium batteries are not listed by the Environmental Protection Agency (EPA) as a
hazardous waste. Therefore, they can typically be disposed of as normal waste.
B D H I
LACK IAMOND ARDWARE NSTALLATION
• The supply plug must comply with section
107-2-D1, standard DK2-1a or DK2-5a.
• The supply plug must comply with SEV/ASE 1011.
B
ATTERY
G
UIDE
or colored yellow/green.
I S I
MPORTANT AFETY NFORMATION
A-3